FEM & ISO Warehouse Racking Safety Standards – 2025 Guide | Long Quyen

Standards

FEM & ISO Warehouse Racking Safety Standards – What Businesses Need to Know

Warehouse racking collapses not only damage goods but also endanger employees’ lives. According to international statistics, 80% of racking accidents could be prevented if safety standards were properly followed. This article explains the FEM and SEMA standards and routine warehouse racking inspection procedures.

International warehouse racking safety standards

StandardsOrganizationScope
FEM 10.2.02Europe (FEM)Inspection and damage assessment of steel warehouse racking
EN 15512Europe (CEN)Structural design of steel pallet racking
SEMA CodeUnited KingdomWarehouse racking design, installation and inspection
AS 4084AustraliaAustralian/New Zealand standard for steel storage racking
ISO 9001:2015InternationalQuality management system for racking production

Long Quyen manufactures racking under ISO 9001:2015 and designs according to FEM/EN 15512 principles, ensuring products meet safety requirements for both the domestic and export markets.

Need advice on choosing the right racking?

Long Quyen engineers analyze your actual warehouse operation and propose the optimal solution free of charge.

FEM 10.2.02 color-coded rack damage assessment system

Warning colorDamage levelRequired action
🟢 GreenNo significant damageContinue normal use
🟡 AmberMinor damage — monitorSchedule repairs and temporarily reduce the load
🔴 RedSerious damageUnload immediately, stop using, then repair or replace

Routine warehouse racking inspection procedure

  1. Monthly inspection by the warehouse manager: visually inspect the entire racking system and mark any suspect locations.
  2. Annual inspection by a specialist: measure deflection and misalignment, check bolts, and assess damage using the FEM color system.
  3. Post-impact inspection: any forklift impact with the racking must be reported and inspected before the racking is used again.
  4. Inspection records: keep complete inspection reports, photos and corrective actions on file.

The most common safety mistakes in Vietnamese warehouses

  • Loading beyond the design capacity — the number one cause of racking collapse
  • No column protectors — uprights are easily hit by forklifts
  • Too little clearance between goods and beams — loads catch on beams during put-away and retrieval
  • Racking not properly anchored to the floor or wall
  • Continuing to use bent or deformed racking without repair

Frequently asked questions

What are the FEM and SEMA standards?

FEM (Fédération Européenne de la Manutention) is the European standard for the design and safety of industrial warehouse racking. SEMA is the equivalent British standard. FEM 10.2.02 sets out the procedure for inspecting and assessing rack damage.

Does warehouse racking need regular inspection?

Yes. Under FEM 10.2.02, warehouse racking should receive a comprehensive inspection by a qualified person at least once a year, plus regular monthly inspections by the warehouse manager. Racking must be inspected immediately after any forklift impact.

Can a bent upright still be used?

No. Even a slightly bent upright significantly reduces load capacity and risks collapse. It must be replaced immediately. Long Quyen supplies replacement components and on-site racking safety inspection services.

Need advice on choosing the right racking?

Long Quyen engineers analyze your actual warehouse operation and propose the optimal solution free of charge.